How to clean your iron with only two ingredients! 31



View Profile

Did you know that you should clean your iron? A dirty iron could be ruining your clothes.

As a result of using tap water, there can be mineral deposits or lime scale on the ironing plate, not to mention the dirt, rust, grime and fabric fluff!

So what can you do to get off this gunk so you don’t transfer it to your clothes?

All you need is bicarb soda and vinegar…


1. Take some paper towel and drench it in vinegar. Place on countertop and lay the cool iron over it. After five minutes take it off and wipe the bottom of the iron.

2. Some of the gunk will loosen but once you have gotten off as much as you can with just the vinegar, get a separate paper towel and dip in mixture of water and bicarb soda. Run the iron over the several times.

3. Once it’s all clean, put your iron on the steam setting and the bicarb soda that got stuck in the holes will start to come out. Clean it up, steam again, clean it up and so on until all the bicarb is out.


Originally published here

Starts at 60 Writers

The Starts at 60 writers team seek out interesting topics and write them especially for you.

  1. Yes I have a steam iron and yes it still gets used on occasions.

    If it is used correctly that is, always push it forward so that the heat in the heel of the iron removes all of the steam in the garment one will always get a good finish.

    At the completion of use it must be emptied and while still switched on held over the sink to ensure all of the water is removed from the tank.

    For best results use distilled water. B|

Leave a Reply

Your email address will not be published. Required fields are marked *